
60TPH LM35-3N Slag Grinding Mill In Fujian, China
Equipment: LM35-3N Vertical Mill, LM17-2N Vertical Mill
Material: Water slag, gypsum, cement fuel
Capacity: 55-60T/H
Output size: 400 SSa
Location: Fujian, China
Using time: 2020
Introduction
The materials in the grinding mill are crushed by the grinding roller and the grinding ring. After screening by the classifier, the qualified materials are transported to the cyclone powder collector by the air blown by the blower, and the finished products are output through the discharge valve. The unqualified materials are knocked down by the classifier and then ground again. The annual output of slag micro powder is 400000 tons, so the demand of capacity is large. The equipment was put into operation in Fujian in 2020. The layout is reasonable and the operation is stable. It has achieved intelligent and pollution-free production while the capacity meeting the requirements of customers.
Recommended Case
- > Limestone sand powder preparation
- > LM vertical roller mill for limestone powder making
- > Limestone production line in Vietnam
- > Limestone sand powder preparation in India
- > 60TPH LM35-3N Slag Grinding Mill In Fujian, China
- > 17TPH MTW178 Limestone Grinding Mill In Xinjiang, China
- > 7TPH MTW145G Limestone Grinding Mill In Sichuan, China
- > LM150N Vertical Mill, Process slag, 325mesh, 12tph
- MORE